B2A6 4896s Instruction Display Description
Share
|
V4896S instrument specifications |
-
Temperature: 0-50℃
Display
Dual 5-bit high brightness red leds
Humidity: 20-90%RH
Output excitation voltage
5V±5% (to power the sensor), current <50MA
± 0.2% F.S±1 word
Supply voltage
AC195 ~ 242V, power consumption < 5w
0.2 seconds; Can be increased to 0.05 seconds
-
"∧" key: rise key "CLR" key: peak clear key or peeling key (upper and lower limit meter)
-
Description of Contents:
Symbol
First name
Range
SAL
OUT1 Relay
00000~ full scale
SPL
OUT1 deviation
0<SPL<SAL
SAH
OUT2 Relay
00000~ full scale
SPH
OUT2 deviation
0<SPH<SAH
SL
Zero point calibration value
00000
SH
Load the calibration value
More than half of full scale
Sd
Decimal point position
0 ~ 3
Id
Index value
1,2,5,10,20
CLTF
Peel key selection
0(peeled), 1 (not peeled)
FIL
Weight filtering degree
1 to 9
OUTF
Alarm Output selection
0 ~ 3
FHH
Peak threshold value (press the ">" key to power on set to 2, the menu appears)
00001~ Full scale *10%
-
Operating instructions:
- Press the "SET" key for more than three seconds to display "SAL" for OUT1 relay Settings, and then press the "SET" key to display "SPL", then the deviation of OUT1 can be set.
- Press "SET" key to display "SAH", OUT2 relay setting can be carried out; Then press "SET" key to display "SPH" to set the deviation of OUT2, the setting method is the same as above.
- Press the "SET" key to display "CIN", which means enter the password, and exit automatically if the password is wrong (the factory password is "00000").
- Press "SET" key to display "SL", no load, zero calibration
- Press "SET" key to display "SH", load calibration can be carried out, plus the load (at least half of the full scale), input the corresponding display value.
- Press "SET" key when "Sd" appears, then it means to adjust the decimal point setting, press the rise key to change the decimal point setting,
- Press "SET" key display "Id" can set the index value of the instrument;
- Press "SET" key to display "CLTF" to select the peeling key, when "CLTF" is 0, press "CLR" key to peel the instrument, when it is 1, can not peel the instrument;
- Press "SET" key to display "FIL" to set the weight filtering degree, the degree can be selected from 1 to 9, the larger the value, the slower the display, this value affects the stability mark.